so do u wanna make a skull mold?
well if you do here is how i did it. firts i went to the automotive section of kmart and bought the little metal skulls that go on your tire as a valve stem cap. then i went to the hardware store and bought long threaded bolt to attach it to. next tape up the handle with some electrical tape.
now u should have a metal skull on a handle.
it will have two plastic red eyes that gotta go. Get a blob of clear red hot and press it on the face of the scull after a few tries the plastic will have burnt out from the eyes, and now your ready to go.
so now u got this device what do u do with it? i suggest something with dichro.
well i hope this helps someone out, tell me what u think.
Email This To a Friend
Topic Commands
Click to receive email notification of replies 
Click to stop receiving email notification of replies